Post by jeffs on Apr 11, 2009 11:27:10 GMT -5
If you just cant get the safety to work right, it is probably because these two surfaces are worn or maybe have a burr. Carefully stone these surfaces smooth and square (it'll improve your trigger pull too!)
This causes excess interferience here, where the safety engages the cocking piece. You can see that this one has rough marks. It is difficult to move. Stone this surface smooth and burr free and grease it well with some thick grease, and all should be well.
If that still doesn't git er done, you can carefully and slowly taper this surface until the safety cam catches it asily and pulls it back. Check your work often because you can take too much off fairly easily.
Good luck and happy shooting.
This causes excess interferience here, where the safety engages the cocking piece. You can see that this one has rough marks. It is difficult to move. Stone this surface smooth and burr free and grease it well with some thick grease, and all should be well.
If that still doesn't git er done, you can carefully and slowly taper this surface until the safety cam catches it asily and pulls it back. Check your work often because you can take too much off fairly easily.
Good luck and happy shooting.